AQUAPAC 158

The Aquapac 158 case is designed for electronics which require a thin wire to be connected to them at all times. The special wire-thru clamp at one end allows that wire to stay connected, and be waterproof. The case is usually used by professionals with specialist electronic devices. Suits small wireless transmitters.

FEATURES:

• use all buttons and switches through the case
• also protects from dust, dirt and sand
• supplied with a belt or you can use your own belt
• like most of our cases it'll float if you drop it in the drink
• the seams are high-frequency welded to form a super-strong bond
• this case features our 'TC' Aquaclip which makes the case waterproof to IPX6
• temporary immersion is fine, but not continuous immersion

IMPORTANT NOTES:

• cases with this clamp are for surface use only, but will offer protection from temporary submersion, they are not recommended for prolonged immersion
• when not using the case leave the TC clamp open. If not the wire or tube could eventually cause a permanent distortion of the foam, risking leakage.
• as long as you follow this instruction the clamp will be watertight with or without a wire/tube.
• the maximum thickness of wire/tube around which the TC clamp will seal is 3.5mm.