DPA 4017B
article code
r.micod4017b
DPA 4017B shotgun microphone
€ 16.94 € 14.00
DPA 4017B is available to buy in increments of 1
- Directional pattern: supercardioid, lobe-shaped
- Principle of operation: pressure gradient, with interference tube
- Cartridge type: pre-polarized condenser
- Frequency range: 20Hz to 20kHz, permanent third order high pass filter at 50Hz
- Frequency range, +/-2dB, at 60cm: 70Hz to 18kHz with typ. 3dB soft boost at 15kHz
- Sensitivity, nominal, +/-2dB at 1kHz: 19mV/Pa, -34.4dB re. 1V/Pa
- Equivalent noise level, A-weighted: typ. 13dB(A) re. 20uPa (max. 15dB(A))
- Equivalent noise level, ITU-R BS.468-4: typ. 24dB (max. 26 dB)
- S/N ratio (A-weighted), re. 1kHz at 1Pa (94dB SPL): typ. 81dB(A)
- Total harmonic distortion (THD): <1% up to 137dB SPL peak
- Dynamic range: typ. 124dB
- Max. SPL, peak before clipping: 138dB
- Switchable attenuator, filters etc.: high boost-> +4dB at 8kHz, low cut-> first order filter, below 120Hz
- Output impedance: 100Ohm
- Minimum load impedance: 2kOhm
- Cable drive capability: 100m
- Output balance principle: signal balanced
- Common mode rejection ratio (CMRR): >40dB
- Power supply (for full performance): 48V Phantom power (+/-4V)
- Current consumption: 4.5mA
- Connector: XLR-3M. pin 1: shield, pin 2: signal + phase, pin 3: phase
- Color: matte black
- Weight: 68g
- Microphone/capsule diameter: 19/19mm
- Microphone length: 212mm
- Maximum output voltage, RMS: 2V
- Polarity: +V at pin 2 for positive sound pressure
- Temperature range: -40°C to 45°C
- Relative humidity (RH): up to 90%
| Is available for rent | Yes |
|---|
