SCHOEPS CMC 1 L
The CMC 1 is a small Colette microphone amplifier, about one-third the length and 53% lighter than the CMC 6. It is compatible with all components of the Colette system and can be used in place of the CMC 6 without compromise, for all applications in which the size and weight of the microphone play a role. At Schoeps, "uncompromising miniaturization" means that the electrical characteristics of the CMC 1 are equal to, or even better than, those of the CMC 6. Through modern electronic design, these outstanding electrical properties have been achieved:
- high maximum SPL: 135 dB-SPL with the MK 4 (0.5% THD or less)
- very low current consumption: 2.0 mA at 48 Volts
- operates on 48 V or 12 V phantom power, reliable operation even if powering is somewhat marginal
- very high immunity from RF interference with the SCHOEPS RFI Shield, high immunity to cable-induced hum and other interference (field tested with Audio Limited A 10, etc.)
- flat frequency response
- very low distortion
- constant output impedance across the audio frequency range
- balanced, direct-coupled, class-A output circuit
- output is filtered in the ultrasonic range to prevent interference, e.g. from camera autofocus
A complete Colette-series microphone consists of an MK capsule and a CMC amplifer. All capsules and active accessories of the Colette system are compatible with the CMC 1. The CMC 1 works with standard 12-Volt or 48-Volt phantom powering. Power consumption is lower at 12 Volts - an advantage for battery-powered operation.
FEATURES:
- variant of the CMC 1 U with miniature Lemo output connector
- K 5 LU (5 m cable with XLR-3M plug) and SGC stand adapter are included
- fully equal alternative to the well-known CMC 6
- compatible with all available MK capsules and active Colette accessories, e.g. CUT 60 or RC
- compatible with all accessories of the CCM series, e.g. TR L oder STA
- recommended accessories for boom use are the same as for CCM microphones, e.g. MINIX CCM LU or Rycote INV-5
WHAT'S INCLUDED:
- 1x CMC 1 L Colette miniature amplifier with Lemo output connector
- 1x K5LU 5m Lemo/XLR3M cable
- 1x SGC stand mount
- 1x premium case
- frequency range: 20 Hz-20 kHz
- sensitivity: see corresponding capsule
- maximum output voltage: 1,8 V (5 dbV) with 1kOhm load
- maximum sound pressure level (THD < 0.5 %): 135 dB-SPL (P48) with MK 4 and 131 dB-SPL (P12) with MK 4
- low cut filter: 20 Hz, 12dB/oct
- output impedance: 50 Ohm +/1 Ohm (8 Hz-50 kHz)
- minimum recommended load impedance: 1 kOhm
- common mode rejection ratio (at 1 kHz): > 55 dB
- maximum cable length: > 400m/1300 ft
- Schoeps RFI Shield : yes
- powering standard/valid range: P48/30-52 V and P12 / 11-13 V
- current consumption: 2mA (P48) and 3 mA (P12)
- output: Lemo, analog, 1 channel
- length: 25.5 mm
- diameter: 20 mm
- weight: 28 g
- surface finish: matte grey
Brand | Schoeps |
---|